Newing-Hall/TLC/Domiteaux

1. We recommend that you engrave a sample of the logo when you receive it.
2. Always turn off your engraver before plugging in or pulling out a cartridge.
3. Pull up the lever at the end of the socket to add chips or remove chips from the cartridge.
4. Place the chip in a socket starting with the one on the right or inside end; i.e., U1 first, U2 next, U3, then U4.
5. Place the logo/font chip in the socket with the colored dot at the top of the chip towards the component at the top of the cartridge with the colored dot on it. Failure to do so will cause permanent damage to the chip!! Only put yellow dot chips in a yellow dot (128K) cartridge, and red dot chips in a red dot (256K) cartridge.
6. Some logos and fonts require more than one chip. All chips must be used to make the logo or font work. To use two-, three-, or four-chip logo or font, place the #1 chip to the inside U1 socket followed by the #2 chip in the U2 socket, #3 chip in U3 and #4 chip in U4.
7. With the engraver off, plug the logo/font cartridge into any of the open cartridge slots underneath the control panel. Turn the engraver on.
8. Set up the engraving program.
9. Select the text entry menu. Press ”OPTIONS” for the text entry options.
10. Select Option #1 SELECT FONTS. The screen will display a font menu, numbering all logos and fonts available, up to a total of 14. The four working logos and fonts can now be rearranged to utilize the new one now listed on the font menu. The four working logos/fonts are labeled A, B, C, and D. Press ENTER until you are at the logo/font you wish to substitute. Substitute the one by entering the number of the logo/font displayed in the menu, in place of the number already there.
11. Return to text entry: Select the logo/font you want the same way you normally would. Logos will be engraved by typing the number 1, or whatever additional code we may give you (see label illustration below).

ART-SCRIBE CARTRIDGE (DISK SYSTEMS)

1. We recommend that you engrave a sample of the logo when you receive it,
2. Always turn off your engraver before plugging in or pulling out a cartridge. Failure to do so may result in damage to your cartridge.
3. With your engraver off, plug your new Art-Scrybe cartridge into any of the cartridge slots underneath the control panel. Once the Art-Scrybe cartridge is in place, it may remain there.
4. Turn on the power to your engraving machine.
5. Insert the logo diskette into drive B, the bottom drive of your computer.
6. Set up an engraving program.
7. Select the text entry menu. Press OPTIONS for the text entry options.
8. Select option 4, load Art-Scrybe memory. When the screen prompts with ”FILE NAME”, type B: followed by the logo name as it is written on the diskette; example B: LOGONAME. Note the placement of the colon and the period. The screen will display ”Sending Logo” and return to the test entry options.
9. The window will display four working fonts. Select OPTION 1. Select FONTS. The screen will display a font menu, numbering all fonts available up to a total of 14. The four working fonts can now be rearranged to utilize the new logo/font now listed on the font menu. The four working fonts are labeled a, b, c, and d. Press Enter until you are at the font you wish to substitute. Substitute the font by entering the number of the logo/font displayed in the menu, in place of the number already there.
10. Return to the text entry: select the logo/font you want the same way you normally do. Logos will be engraved by typing the number 1, or whatever additional code we may give you.